what should be paid attention to when machining by CNC lathe
what should be paid attention to when machining by CNC lathe
A workpiece can see not only the strength of a manufacturer, but also how it handles some details. So for CNC lathe machining parts, what should be paid attention to when machining by CNC lathe?
1. The burr on the workpiece surface can be said to be easily overlooked by many manufacturers. Many people say what this part looks like when it comes out, and what it looks like when the finished product is packaged. In fact, for a part, the CNC lathe processing parts are completed by equipment, if it is not trimmed in time the burr, or the the parts are obsolete, it will affect other links during use.
2. Accuracy of parts. For CNC lathe machining parts, its accuracy is very strict. Only when the required accuracy is met can it be used. The accuracy of the parts is judged mainly by the size of the parts. Control ability, if the tolerance is within the specification that the tolerance can fluctuate, then the part is qualified, if it exceeds the tolerance, then it is unqualified.
3. Analysis of the test results. For a component, it is bound to go through a performance test before it leaves the factory. If the performance is qualified, it will be shipped. If it is unqualified, it should be analyzed. For some reasons, this can also avoid mass scrapping. Manufacturers in the processing industry will basically deal with it in this way. They will make a certain quality control chart based on the performance of many companies to analyze the reasons.
- 3 Axis Vertical Machining Center
- 3 Axis Hard Line Vertical Machining Center
- 3 Axis 2 Linear One Hard Line Vertical Machining Center
- 3 Axis Linear One Line Vertical Machining Center
- Heat Treatment Vacuum Furnace
- Heat Treatment Oil Quenching Vacuum Furnace
- Heat Treatment Air Quenching Vacuum Furnace
