The difference in operating steps between Taiye CNC lathes and other companies' CNC lathes
The difference in operating steps between Taiye CNC lathes and other companies' CNC lathes
Generally speaking, Operating CNC lathe should have the following steps, Taiye CNC lathe, Original fool-style CNC lathe, no programming required, saving time and effort.
The difference in operating steps between Taiye CNC lathes and other companies' CNC lathes
1. Writing or programming （Taiye CNC lathe no required programming）
General CNC lathe before processing, the processing program of the workpiece should be compiled first. If the processing program of the workpiece is long and complicated, it is best not to program on the machine tool, but to use programming machine programming or manual programming. This can avoid occupying the machine. For short programs, you should also Write on the program list.
2, Turn on
Generally, the CNC lathe is turned on first, and then the system is turned on. In some designs, the two are interlocked, and the machine cannot display information on the CRT without powering on.
3. Back to the reference point
For machine tools with incremental control systems, this step must be executed first to establish the movement standard of each coordinate of the machine tool.
4, program editing input
If the program input by the CNC lathe needs to be modified, it must be edited. At this time, set the mode selection switch to the EDIT position, and use the edit key to add, delete, and change.
5. The CNC lathe is locked and the program is run
This step is to check the CNC lathe program, if there is an error, edit it again.
6. Workpiece loading, alignment, tool setting
The CNC lathe adopts manual incremental movement, continuous movement or hand-casting moving lathe. Align the tool setting point to the starting point of the program, and align the tool reference.
7. Start coordinate feed for continuous processing
The feed rate during processing can be adjusted by the feedrate override switch. During processing, you can press the feed hold button FEEDHOLD to pause the feed movement, observe the processing conditions or perform manual measurement. Press the CYCLESTART button again to resume processing.
8. Operation display
Using the various screens of the CRT to display the position of the workbench or the tool, the program and the state of the machine tool, so that the operator can monitor the processing situation.
9. Part inspection and removal
In the case that the workpiece is still in the chuck clamp, the workpiece size is detected. If the size of the workpiece is unqualified, the tool should be compensated appropriately, and the workpiece should be removed when the size is qualified.
10, Turn off
Generally, the CNC lathe should be turned off first, and then the system.
