Some commissioning of turning on CNC machine tools
Some commissioning of turning on CNC lathe
CNC lathe is a kind of high-tech mechatronics equipment. It is very important to start and debug in the correct way. This determines to a large extent whether the CNC lathe can exert normal economic benefits and its own service life.
1. Check before starting the CNC lathe: check the peripheral environment of the CNC lathe, whether there is any abnormal phenomenon such as water in the electrical box, and whether the oil has deteriorated.
2. Startup step by step for CNC lathe: The power supply voltage of the CNC lathe must be checked before the machine is turned on. The power switch of the lathe must be turned on after the main power switch is turned on for about 10 minutes, and then the other power switches in the electrical box should be turned on to check whether the voltage is lacking. If the phase sum is too low, turn on the power of the lathe if there is no abnormality, and observe whether there is any abnormality and whether there is air leakage. Do not perform any actions when there is no alarm when the machine is turned on, and let the electrical components energize for 30 minutes.
3. Slow movement the CNC lathe: Check whether there is interference, move the CNC lathe through the handwheel, and pay attention to whether there is any abnormality, and then perform the origin return step.
4. CNC lathe running-in: Run the CNC lathe automatically and slowly for a long time, and rotate the spindle at low speed.
Taiye Machine hope you will maintain the machine and improve the service life of the machine。
- 3 Axis Vertical Machining Center
- 3 Axis Hard Line Vertical Machining Center
- 3 Axis 2 Linear One Hard Line Vertical Machining Center
- 3 Axis Linear One Line Vertical Machining Center
- Heat Treatment Vacuum Furnace
- Heat Treatment Oil Quenching Vacuum Furnace
- Heat Treatment Air Quenching Vacuum Furnace
